COMBITHERM® CLEANING and MAINTENANCE
COMBITHERM INSTALLATION AND MAINTENANCE MANUAL #6004/18
PG. 19
Preventive Maintenance
In addition to the routine maintenance procedures to prevent scale and lime build-up from
forming in the steam generator system, there are several other steps to be taken for both sanitation
purposes, and to keep the oven running at top operating efficiency. These additional safeguards
will help prevent inconvenient down-time and costly repairs.
● DO NOT DISPOSE OF GREASE, FAT, OR SOLID WASTE DOWN THE OVEN
DRAIN. Fats and solids will eventually coagulate in the drain system, causing blockage.
Consequently, water will back-up into the condenser and interior oven compartment,
resulting in an oven that is inoperable.
● MAKE CERTAIN THE DRAIN SCREEN
IS ALWAYS IN PLACE. REMOVE
ANY SOLID WASTE MATERIAL FROM
THE DRAIN SCREEN BEFORE IT
ENTERS THE DRAIN SYSTEM. The
routine removal of solids from the drain
screen will help prevent blockage.
● USE THE AUTHORIZED COMBITHERM OVEN CLEANER ONLY.
The use of unauthorized cleaning agents may discolor or harm the interior surfaces of
the oven.
● TO PROLONG THE LIFE OF THE DOOR GASKET, REMOVE
AND CLEAN THIS ITEM DAILY. The acids and related
compounds found in fat, particularly chicken fat, will weaken the
composition of the gasket unless cleaned on a daily basis.
● TO ADDITIONALLY PROTECT GASKET LIFE, ALLOW
OVEN DOOR TO REMAIN SLIGHTLY OPEN AT THE END
OF THE PRODUCTION DAY.
An open door will relieve the pressure on the door gasket.
● ROUTINELY CLEAN DOOR HINGES. Open oven door to relieve tension. Clean all
parts of the hinge.
● CLEAN WATER INTAKE SCREEN. The routine removal of
solids from the water intake screen will help prevent blockage.
This should be done quarterly or more often depending on the
amount of sediment in the water supply.
To Next Page
Loading...
Need help?
General