C L E A N I N G & M A I N T E N A N C E
37
CLEANING SCHEDULE
DAILY GASKET CLEANING
It is important to prolong the life of the oven gasket by
cleaning on a daily basis. Routine cleaning will help
p
rotect the gasket from deterioration caused by acidic
foods.
1. Allow the oven to cool, then wipe the gasket and
crevices with clean cloth soaked in warm detergent
solution.
2. Wipe the gasket and crevices with a cloth and clean
rinse water.
Do not attempt to remove gasket or place in the
dishwasher.
PROBE USAGE AND CLEANING
After each use of the CORE TEMP mode, wipe the probe
tip with a clean paper towel to remove food debris. Follow
by wiping the probe with a disposable alcohol pad. Return
the probe to the proper door bracket position.
Probe Cleaning Procedures
1. Remove all food debris from probe between loads and
at the end of each production shift. Wipe the entire
probe, probe cable assembly, and probe holding bracket
with a clean cloth and warm detergent solution.
2. Remove detergent by wiping the probe, cable, and
bracket with a cloth and clean rinse water.
3. Wipe probe and probe bracket with disposable alcohol
pad or sanitizing solution recommended for food
contact surfaces.
4. Allow probe and cable to air dry in the probe
holding bracket.
5. Wipe the probe with a disposable alcohol pad prior to
inserting into a new food product.
DAILY OVEN CLEANING
To be performed at the end of the production day or
between production shifts.
DAILY STEAM GENERATOR FLUSH
(Electric boiler equipped models only)
See next page for instructions
The steam generator must be flushed once a day when
operating the oven on a regular basis. This procedure will
prevent lime deposits and scale build-up from forming in
the steam generator. A steam generator flush is
automatically initiated during the cleaning function.
REGULAR DECALCIFICATION
(Electric boiler equipped models only)
Qulified service technician should see
CombiTouch
Technical Manual
for instructions
It is important to decalcify the steam generator,
particularly in areas with extremely hard water. In
addition to the daily steam generator flush, this procedure
should be performed once a month by a qualified service
technician or more frequently depending on usage and
water conditions.
MONTHLY CLEANING
1. Spray Head
2. Water Intake Filter
3. Drain Pipe
2
1
3
To Next Page
Loading...
Need help?
General
