１９
４．Operation(continue)
Be sure to read and understand on the page 3 to 7 “For safety operation” carefully before use
Connecting the wires for the external operation(continue)
●
3 Wiring the signal wire
Wire the signal wire along the shape of inside of the inspection door like other wiring.
Bundle the signal wire using a union band etc. at this time. Thread the tied signal wires
through slit grommet by the side of a inspection door and electrical equipment.
Connect the tied signal wires each terminal block.
(Refer to Procedure (4) and Procedure (5) for the connection method.)
Si
nal wire
W
ire the signal wire
passed into the electric
part to each terminal box.
Destination terminal BOX
Slit the grommet
and let the tied
signal wire pass
to the electric
part.
<The NG example>
The act such as hooking the tied
signal wire on the convex portion (L
character portion) of the check
door, or shutting a check door with
the condition with the wire inserted
into the hinge.
Bundle the signal wire
together with other cables
using a union band etc.
Moreover, when you shut
a check door, please shut
carefully not to crush on
both sides of the tied
signal wire between a
inspection door and this
electrical equipment.
Hinge
To Next Page
Loading...