© Copyright 2014 Amano McGann, Inc. OPUS7000_Installation_10032014 19
OPUS-7000 Installation Manual
OPUS-7000 PROCEDURES
2.1 Opening the Paystation Door
1. Insert two of the main door access keys into the upper and lower locks of the
Paystation.
2. Push the key in and simultaneously turn the key 90 degrees to the left.
3. Unlock the remaining lock.
4. Pull the Paystation door to open.
2.2 Powering ON the Paystation
1. Open the Paystation door.
2. The power button is a red rocker switch located in the lower-right section of
the Paystation. Flip the rocker switch upwards to turn the Paystation ON.
IMPORTANT: Please do not turn the Paystation ON immediately after
the Paystation is turned OFF. It is recommended to wait five seconds
as the sudden power can damage Paystation hardware.
2.3 Entering the Management Menus
To configure the internal settings of the Paystation, the Management Switch
needs to be toggled while the Paystation is in its idle state.
1. Verify the Paystation is ON and Idle.
2. Open the Paystation door.
3. Toggle the Management Switch located in front of the iCore board. The
Paystation displays the First Time Operation menu.
[Fig 2.3A] Management Switch
To Next Page
Loading...
