Amano OPUS-7000 Series - Removing the Coin Hoppers

To Next Page

To Previous Page

OPUS-7000 Installation Manual

2.9 Removing the Coin Hoppers

Note: Only remove the coin hoppers for troubleshooting purposes.

Removing and dumping the coin hoppers is not the correct inventory

procedure.

1. Open the Paystation door

2. Power OFF the Paystation.

3. Insert the ‘68’ key into the middle coin dispenser lock. Push the key in and

simultaneously rotate the key 90 degrees to the left/counter-clockwise.

4. Pull the coin door open and pull the coin hopper drawer handle until the coin

hopper drawer is fully extended.

5. Disconnect the cable on the front of the coin hopper

6. Push down on the handle (designated by [Fig. 2.9A]) and simultaneously tilt

the hopper upwards. The hopper will tilt to a 45 degree angle and stop.

7. Pull the hopper horizontally towards the right side of the Paystation to slide

the hopper out of its rails.

[Fig. 2.9A] The left hopper is tilted at its maximum angle. Pull horizontally to remove.

Other manuals for Amano OPUS-7000 Series