Amano OPUS-7000 Series - Removing the Bank Note Acceptor

© Copyright 2014 Amano McGann, Inc. OPUS7000_Installation_10032014 21
OPUS-7000 Installation Manual
2.5 Removing the Bank Note Acceptor
1. Open the Paystation door.
2. Power OFF the Paystation.
3. Remove the ground cable attached to the inside-front of the Bank Note
Acceptor (BNA) using a Phillips head screwdriver.
4. Once the ground wire is removed, pull up on the bottom lock handle of the
Bank Note Acceptor while simultaneously pulling the BNA towards the front of
the Paystation.
[Fig. 2.5A] Ground Wire (Circled) and Lock Handle (Rectangle)
5. To re-insert the Bank Note Acceptor, push the BNA straight back until it locks.
Re-attach the ground cable and start the Paystation when finished.
Note: The LED on the front of the Bank Note Acceptor represents if
the BNA is ready to accept notes. If the LED is green the BNA is
ready to accept notes. If the LED is red it is not ready to accept notes.