© Copyright 2014 Amano McGann, Inc. OPUS7000_Installation_10032014 40
OPUS-7000 Installation Manual
CONFIGURING THE PAYSTATION
5.1 Creating Management Cards
1. Open the Paystation door and flip the Management Switch located in front of
the iCore board.
2. The Paystation will load the First Time Operation menu. Press Next to
continue to page 2.
3. Press Management Menu and insert the Management password
(C1441104). Press the green E when finished.
4. Once the Management Menu has loaded, press Card Issue. Insert the
Management password if necessary.
[Fig. 5.1A] Press Type and select the mgmt. card type to create
5. Press Type and select the type of card desired to create.
6. Press Ok and Return to return back to the Card Issue menu.
7. Press Start to start creating the card.
8. Insert a blank ticket into the REPM. The REPM will spit the ticket back out
once the ticket has been successfully encoded. Press Stop when finished
creating the card type. Write down the card type on the ticket.
9. Repeat steps 5-8 to create the remaining card types. Create at least one card
for each card type.
10. Exit the Card Issue menu when finished.
To Next Page
Loading...
