Faults
38
AMALOG BAH0017.1 11.08
9.3 Fault message - fill level too low
Alarm message - insufficient seed
When the level sensor is activated
• the display (Fig. 38) appears
• an acoustic signal (triple signal tone) is
emitted.
Fig. 38
The display switches.
The control symbol (Fig. 39/1) marks the fill level
symbol.
The alarm is repeated when the seed drill is used
again, e.g. after turning at the end of the field.
Fig. 39
The same display appears on the DMC Primera also in event of a
malfunction of the seed sowing shaft.
To Next Page
Loading...