Amazone AMADOS E+S

To Next Page

To Previous Page

Use

AMADOS BAG0083.2 11.17

6 Use

DANGER

When using the machine, refer to the operating manual for the

spreader.

Before use, enter:

• Desired spread rate (job).

• Desired working width

• Product (mode 2)

• Intended average speed (mode 7).

• Calibration factor

or determine the calibration factor by means of a spread rate

check.

During use, the accumulating data for the current job can be dis-

played.

Procedure for use

1. Switch on the AMADOS

E+S

Select the job

• Check the specified quantity or

• Enter the specified quantity and confirm.

Back to work menu.

4. Move off and start the automatic quantity regulation.

ο Start the automatic quantity regulation or

start the automatic quantity regulation with predos-

ing for the first metres.

Check whether the actual working width corresponds to that set on

the AMADOS

E+S

• The spread rate is regulated automatically.

• The shutter closes at speeds below 1 km/h.

• The shutter opens at start-up

Amazone AMADOS E+S - 6 Use