Amazone AMADOS+ - Checking Discharge Outlet Dimension

Repair, maintenance and cleaning
23
AMADOS
+
DB 1001 01.04
3. Checking the dimension of the opened dis-
charge outlet

When actuating the shutter slides, do
not reac
h into the discharge opening!
Danger of squeezing!
- The setting gauge (Fig. 2
/1) must easily fit through
the now released discharge opening di
ameter.
(Special option, Order-No.:: 915018).
Should this not be the case (opened discharge
outlet diameter too small or too big) readjust the
fixing of the setting motor bracket with the link-
age for the shutter slide as follows:
- Slacken the fixing bolts (Fig. 2
/2) of the setting
motor console (Fig. 2/3).
- Insert the setting gauge (Fig. 2/1 into the dis-
charge outlet opening.
- Swivel the setting motor console (Fig. 2/3) to-
wards the setting gauge and retighten the fixing
bolts (Fig. 2/2).
Fig. 2
Check whether the shutter position 41 for the meter-
ing shutter slides is shown on the spread rate setting
scale. If necessary slacken the pointer fixing (
Fig.
3/1) and align the pointer read off edge (Fig. 3
/2) onto
the scale figure 41.
,
If the values for the read off shutter slide
positions of the two shutters are far be-
yond the indicated maximum values, a
fault in the control system or on the set-
ting motor can be assumed. In this case,
check the impulse value of the setting
motors.
Fig. 3