LED
Figure 1
2. BEFORE inserting the batteries, locate the dip switches on the inside
cover of the lid of the transmitter.
Figure 2
Figure 2
3. Channel Number: The WS-08 supports up to eight transmitters. To set
each channel number (the default is Channel 1), change Dip Switches 1, 2 and
3, as referenced in Table 1.
4. Temperature Units of Measure: To change the transmitter display units of
measure (°F vs. °C), change Dip Switch 4, as referenced in Table 1.
Table 1
displays all four switches in the OFF position (factory default setting).
Version 1.0 ©Copyright 2013, Ambient LLC. All Rights Reserved. Page 3
DIP SWITCH
FUNCTION
Channel 1
Channel 2
Channel 3
Channel 4
Channel 5
Channel 6
Channel 7
Channel 8
°F
°C
To Next Page
Loading...
Need help?
General
