U10C034 Telephony Version v1.4 June 2008
24
emtaSignalingDQoSActivationModel twoPhase(2) read
emtaSignalingGR303Support disabled(2) read
emtaSignalingDefRtcpDSCP 0 read-write
maxResetDelay/emtaMaxResetDelay
(1.3.6.1.4.1.4413.2.2.2.1.6.1.11.0 Unsigned32)
This object identifies the length of time, in seconds, that the MTA should
wait after the software download for syslog event and reset there after.
MTA will start a timer with this value after the completion of the SW
download and an active phone call, upon expiry it will send an event notifying
of the reset and restart the timer with the same value and upon second
expiry MTA will be reset. This prevents software download reset from
interrupting an active phone call. The default value of zero disables
the reset delay and resets the unit immediately after the software download.
postCallCompletionResetDelay/emtaPostCallCompletionResetDelay
(1.3.6.1.4.1.4413.2.2.2.1.6.1.12.0 Unsigned32)
This object identifies the length of time, in seconds, that the MTA should
wait after terminating a call before resetting the MTA if a reset is pending
after the software download completion. The default value of zero disables
the reset delay and reset the unit immediately after a software download.
emtaIncludedInCmMaxCpe
(1.3.6.1.4.1.4413.2.2.2.1.6.1.4.0 Integer32)
This object specifies whether the EMTA MAC address will be included when
calculating the number of CPEs allowed by the CM as specified in the CM
configuration file. Setting of the MIB takes effect on the next re-boot.
Note that the eDOCSIS specification requires the value of this object
to be true(1) and setting it to false(2) will violate the spec and render
the device uncertifiable.
emtaUseAlternateTelephonyRootCert
(1.3.6.1.4.1.4413.2.2.2.1.6.1.6.0 Integer32)
This object controls which telephony root certificate the MTA will be
using during its authentication phases. As per PacketCable 1.x, the
telephony root certificate should be used so that it can be modified by
way of a firmware upgrade if necessary. However, the alternate certificate
may sometimes be required for testing, development, or other special
situations. If set to true(1), the EMTA will use the alternate telephony
root certificate provisioned in non-volatile storage. If set to false(2),
the EMTA will use the telephony root certificate which is embedded in
the firmware image.
emtaInhibitNcsSyslog
(1.3.6.1.4.1.4413.2.2.2.1.6.1.8.0 Integer32)
This object controls the logging of the NCS messages to Syslog. Generally,
To Next Page
Loading...
