U10C034 Telephony Version v1.4 June 2008
48
emtaSignalingDevToneFreqOnDuration and
emtaSignalingDevToneFreqOffDuration). This object should only be changed
by the configuration file.
2.2.11 DQoS Lite Enable
emtaEnableDQoSLite
(1.3.6.1.4.1.4413.2.2.2.1.6.1.7.0 Integer32)
This object specifies whether DQoS Lite is enabled. When enabled,
gateid enforcement is disabled, which makes the EMTA use service
flows (lite DQoS) even in absence of gate IDs. When DQoS lite
is disabled, gate ID enforcement on the EMTA is enabled, which
makes the EMTA use real DQoS (no lite DQoS).
2.2.12 RFC2833 Enable
emtaSignalingDtmfToneRelayRFC2833Support
(1.3.6.1.4.1.4413.2.2.2.1.6.4.8.0 Integer32)
This object contains the value which controls the usage of the
RFC2833 DTMF Relay. Setting this object to 'enabled(1)' causes
the MTA to use the DTMF Tone Relay as per RFC2833. Setting this
object to 'disabled(2)' causes the eMTA not to use RFC2833 for
DTMF Tone Relay. Setting this object to 'subtract(3)' causes eMTA
to subtract DTMF tones from the encoded audio but not generate
RFC2833 packets.
‧ enabled(1),
‧ disabled(2),
‧ subtract(3)
2.2.13 Configure MTA syslog server Ip address.
pktcEvent.mib
MIB Default Value Access
pktcDevEvSyslogAddress
Prov. Server IP read-write
pktcDevEvSyslogAddress
(1.3.6.1.4.1.4491.2.2.3.1.3.0 InetAddress)
This MIB Object contains the IP address of the Syslog server. If this
is set to either 0.0.0.0 or 255.255.255.255 the device MUST inhibit
syslogtransmission. The use of FQDNs is syntactically allowed, but
discouraged since a failure to resolve them in a timely manner may leave
the device without access to the Syslog daemon during critical network
events. The type of address this object represents is defined by the MIB
Object pktDevEvSyslogAddressType.
If an SNMP SET results in a type that does not match that indicated by
the MIB Object pktcDevEvSyslogAddressType, the PacketCable device MUST
To Next Page
Loading...
