67
DOCSIS service flows
CM IP and DHCP options
Routing table
Time of day
Upstream descriptors
Upstream status
HW Counters
Hal debug
4.3 EMTA
Provides the commands to show and control EMTA relative information and settings.
diag
Runs various MTA diagnostics including:
Reset a line
Run line diagnostics and report results
Enable analog loopback on a line
Sends HD and HU NCS message to the call agent
Simulates line off hook for a short interval of time
Triggers a Log Event in the MTA, sending a SysLog or SNMP Trap if necessary
Force one of the processor to assert and crash
Prints voice statistics at specified intervals
log
Enable or disable message logging.
ping
Pings to the specific IP address from EMTA IP stack.
reset
Reset the mta now
set
Many MTA parameters could be configured like:
Requested DHCP option number [122|177]
Inhibit SW download during call
RFC2833 DTMF Tone Relay
T.38 Fax Relay
Enable the EMTA IP stack firewall
Jitter buffer type and parameters
Line voltage maintenance on reboot, sync loss and CMS down
Boosted loop current
Inclusion of MTA in CM max CPE limit
Set up PHS enabled and suppressed fields
To Next Page
Loading...
