U10C034 MSO User’s Manual v1.4 June 2008
37
emtaSignalingEndptConnectionCleanupTimeo
ut
60 Read
emtaSignalingEmtaResetCleanupTimeout 0 Read
emtaSignalingEndptConnectionCleanupTimeout
(1.3.6.1.4.1.4413.2.2.2.1.6.4.12.0 Unsigned32)
This object causes the EMTA to tear down and clean up connections and
the associated service flows on any endpoint that detects a transition
from off-hook to on-hook, remains onhook for a period longer than the
value set in this MB object, and has connections that were active prior
to the endpoint going onhook. If the MIB object is set to 0 then this
function is disabled. If the MIB is set from 1 to 64000 seconds then the
feature is enabled and this value is used for the timeout. This object
should only be changed by the configuration file.
emtaSignalingEmtaResetCleanupTimeout
(1.3.6.1.4.1.4413.2.2.2.1.6.4.13.0 Unsigned32)
This object causes the entire EMTA to reset if voice connections have
been active and both voice lines have been on-hook for a period greater
than the value defined via this MIB object. This will guarantee that orphaned
connections and/or service flows are properly cleaned up and freed when
the CMTS and CMS fail to perform the correct clean up operations. It will
also ensure that the EMTA state machine, DSP voice channels, NCS connection
handling, etc. are also restored to a default state. This protects against
any unknown case that could possibly cause stuck service flows and/or
connections. If the MIB object is set to 0 then this function is disabled.
If the MIB is set from 1 to 64000 minutes then the feature is enabled
and this value is used for the timeout. This object should only be changed
by the configuration file.
2.2.8 EndPoint Provisioning
brcm-emta-mgmt.mib
MIB Default Value Access
emtaRingWithDCOffset false read-write
emtaSignalingEndptCtrlAnalogLoopback false read-write
emtaSignalingEndptCtrlLineReset false read-write
emtaSignalingEndptCtrlBoostedLoopCurrent false read-write
emtaSignalingEndptCtrlTxGain 0 read-write
emtaSignalingEndptCtrlRxGain 0 read-write
emtaSignalingEndptCtrlDialToneMsecTO 0 read-write
To Next Page
Loading...
