Ambit U10C034 - Configuring for Network Maintenance Operations

U10C034 MSO User’s Manual v1.4 June 2008
33
2.2.6 Configuring for Network Maintenance Operations
The network maintenance operations provide control over the loop voltage
behavior of the eMTA, and they can be done by either the private
emtaMgmtMaintenance MIBs or the PacketCable
pktcEnNcsEndPntLVMgmtTable MIBs. By default, the private MIBs are used.
The PacketCable MIBs are used only for PacketCable 1.5 builds without
vendor-specific build option.
mtaSecurityMib.mib
MIB Default Value Access
MaintenanceWindowBegin - read-write
MaintenanceWindowDuration 0 read-write
MaintenanceControlMask maintenanceOnCm
Reset(0),
maintenanceOnRFL
oss(1),
maintenanceOnMta
Reset(2),
maintenanceOnCM
SLoss(3),
read-write
MaintenanceQuarantineTimeout 0 read-write
MaintenanceDisconnectedTimeout 0 read-write
MaintenanceRFDisconnectTimeout 0 read-write
You can also configure these values via following MIBs.
brcm-emta-mgmt.mib
MIB Default Value Access
emtaMaintenanceWindowBegin - read-write
emtaMaintenanceWindowDuration 0 read-write
emtaMaintenanceControlMask maintenanceOnCm
Reset(0),
maintenanceOnRFL
oss(1),
maintenanceOnMta
Reset(2),
maintenanceOnCM
read-write