Ambit U10C034 - Page 38

U10C034 Telephony Version v1.4 June 2008
38
emtaSignalingEndptCtrlToneDetectionControl AlarmPOSDisabled(4) read-write
emtaSignalingPowerRingFrequency f20Hz(1), read
emtaSignalingRingWaveform Sinusoidal(1) read-write
emtaRingWithDCOffset
(1.3.6.1.4.1.4413.2.2.2.1.6.1.3.0 Integer32)
This object specifies whether the ring with DC offset option is enabled.
emtaSignalingEndptCtrlAnalogLoopback
(1.3.6.1.4.1.4413.2.2.2.1.6.4.1.1.1.x Integer32)
This object controls the implementation of the analog loopback by the
MTA. When the object is set to true(1), the MTA MUST implement analog
loopback operations. When the object is set to false(2), the MTA MUST
stop loopback operations immediately. The default value of this object
corresponds to the functionality compliant with the PacketCable
requirements.
emtaSignalingEndptCtrlLineReset
(1.3.6.1.4.1.4413.2.2.2.1.6.4.1.1.2.x Integer32)
This object controls the resetting the telephone line. Setting this object
to true(1) causes the eMTA to reset the telephone line of the corresponding
endpoint. Setting this object to false(2) does not have any affect. Reading
this object always returns 'false(2)'.
emtaSignalingEndptCtrlBoostedLoopCurrent
(1.3.6.1.4.1.4413.2.2.2.1.6.4.1.1.8.x Integer32)
This object indicates whether the loop current should be boosted (true(1))
or not (false(2)). The particular value for the loop current depends on
the particular hardware (SLIC) being used.
emtaSignalingEndptCtrlTxGain
(1.3.6.1.4.1.4413.2.2.2.1.6.4.1.1.9.x Integer32)
This Object represents the per line transmitter (A/D) gain. A positive
number reflects a signal gain; a negative number reflects a signal loss.
This Object does not reflect the desired level at the Telco (POTS) a-b
(T/R) terminals as it does not include the affects of the gain settings
on the analog interfaces which are pre-configured for a given country
specification. The gain setting specified in this MIB object will be applied
on top of the preconfigured settings and therefore represents a relative
level, while ambitTxGain will overwrite the preconfigured settings and
represents a absolute level.
emtaSignalingEndptCtrlRxGain
(1.3.6.1.4.1.4413.2.2.2.1.6.4.1.1.10.x Integer32)