U10C034 Telephony Version v1.4 June 2008
26
If silence suppression will never be enabled by the CMS, all bits may
be set.
Note that this setting only applies if emtaPhsConfiguration is set to
enabled(1). If emtaPhsConfiguration is set to disabled(2), then the value
of this object will be ignored.
‧ ethDA(0),
‧ ethSA(1),
‧ ethEtherType(2),
‧ ipVersionIHL(3),
‧ ipTOS(4),
‧ ipTotalLength(5),
‧ ipIdent(6),
‧ ipFlagsFragOffset(7),
‧ ipTTL(8),
‧ ipProtocol(9),
‧ ipHeaderChecksum(10),
‧ ipSA(11),
‧ ipDA(12),
‧ udpSourcePort(13),
‧ udpDestPort(14),
‧ udpLength(15),
‧udpChecksum(16)
emtaPhsDownstreamMask
(1.3.6.1.4.1.4413.2.2.2.1.6.1.17.0 BITS)
This object sets the PHS mask for downstream voice DQoS flows using IPv4
addressing. Setting a bit to '1' will cause the CMTS to suppress this
field for downstream voice flows.
The default configuration is the ethEthertype(0), ipVersionIHL(1),
ipIdent(4), ipFlagsFragOffset(5), ipProtocol(7), ipSA(9), ipDA(10), and
udpDestPort(12) bits are set.
If silence suppression will never be enabled by the CMS, ipTotalLength(3)
and udpLength(13) may also be set.
If silence suppression will never be enabled by the CMS and
emtaPhsDownstreamVerification is set to either disabled(2) or auto(3),
all bits may be set.
Note that this setting only applies if emtaPhsConfiguration is set to
enabled(1). If emtaPhsConfiguration is set to disabled(2), then the value
To Next Page
Loading...
