U10C034 Telephony Version v1.4 June 2008
28
emtaSignalingMaxNumberQueuedNcsEvents
(1.3.6.1.4.1.4413.2.2.2.1.6.4.10.0 Unsigned32)
This object contains the max number of queued NCS events that the MTA
can store during the lock step.
emtaSignalingRtpBaseReceiveUdpPort
(1.3.6.1.4.1.4413.2.2.2.1.6.4.11.0 Unsigned32)
This object contains the UDP Port Number used by the EMTA for RTP connection.
RTP (and RTCP) ports for all connections will be based on this port.
emtaSignalingT38FaxRelaySupport
(1.3.6.1.4.1.4413.2.2.2.1.6.4.14.0 Integer32)
This object contains the value which controls the usage of the T38 Fax
Relay. Setting this object to 'true(1)' causes the EMTA to use the T38
Fax Relay if supported by the DSP image. Setting this object to 'false(2)'
causes the EMTA not to use T38 Fax Relay, but to use voice-band data mode
for fax transmission instead.
emtaSignalingEcanTailLength
(1.3.6.1.4.1.4413.2.2.2.1.6.4.15.0 Integer32)
This object specifies the echo cancellation tail length. If the echo
cancellation tail length is changed through SNMP, then those changes take
effect starting with the next phone call (in process calls are not affected).
Also note that the value of this object will persist across a MTA reset."
‧ ecanTail8ms(1)
‧ ecanTail16ms(2)
‧ ecanTail24ms(3)
‧ ecanTail32ms(4)
emtaSignalingDQoSActivationModel
(1.3.6.1.4.1.4413.2.2.2.1.6.4.16.0 Integer32)
This object controls the DQoS activation model. Setting this object to
singlePhase(1) causes the eMTA to employ the single phase model where
both reservation and commitment occur as a single autonomous operation.
Setting this object to twoPhase(2) causes the eMTA to employ the two-phase
model where the application reserves the resource, and later commits it.
This object should only be changed by the configuration file.
‧ singlePhase(1)
‧ twoPhase(2)
emtaSignalingGR303Support
To Next Page
Loading...
