U10C034 Telephony Version v1.4 June 2008
82
This MIB module supplies the basic management objects for the MTA Device. The MTA MIB only supports
a single provisioning server.
pktcMtaDevResetNow
Setting this object to true(1) causes the eMTA to reset. Reading this object always returns false(2).
When set to true, the following actions occur:
1. All connections (if present) are flushed locally.
2. All current actions such as ringing immediately terminate.
3. Requests for notifications such as notification based on digit map recognition are flushed.
4. All endpoints are disabled in resetting state.
5. The provisioning flow is started at step MTA-1 of the provisioning process.
pktcMtaDevMacAddress
The MTA MAC address for this device.
pktcMtaDevFQDN
The Fully Qualified Domain Name for this MTA.
pktcMtaDevEndPntCount
The physical end points for this MTA.
pktcMtaDevEnabled
The MTA Administrative Status of this device, where true(1) means the voice feature is enabled and
false(2) indicates that it is disabled.
pktcMtaDevProvisioningState
The completion state of the initialization process, sent as part of the final INFORM (step MTA-25 of
the provisioning process). The states are:
pass(1)—the configuration file could be parsed successfully and the MTA is able to reflect the same in
its MIB.
inProgress(2)—the configuration file is currently being processed.
failConfigFileError(3)—the configuration file was in error due to incorrect values in the mandatory
parameters.
passWithWarnings(4)—the configuration file had proper values for all the mandatory parameters but
had errors in the optional parameters (including any vendor specific OIDs which are incorrect or not
known to the MTA).
passWithIncompleteParsing(5)—the configuration file is proper, but the MTA cannot reflect the
same in its MIB (for example, too many entries leading to memory exhaustion).
failureInternalError(6)—the configuration file cannot be parsed due to an internal error.
failOtherReason(7)—the MTA cannot accept the configuration file.
pktcMtaDevHttpAccess
Indicates whether HTTP file access is supported for MTA configuration file transfer.
pktcMtaDevProvisioningTimer
Enables setting the duration of the provisioning timeout timer. The timer covers the provisioning
sequence from step MTA-1 to step MTA-23. The value is in minutes and setting the timer to
0 disables
this timer. The default value for the timer is
10.
pktcMtaDevProvisioningCounter
This object is the count of the number of times the provisioning cycle has looped through step MTA-1
since the last reboot.
pktcMtaDevErrorOidsTable
If pktcMtaDevProvisioningState is reported with anything other than a pass(1), then this table is
populated with the necessary information, each pertaining to observations of the configuration file.
Even if different parameters share the same error (for example, all Realm Names are invalid), all
recognized errors must be reported as different instances. This contains the necessary information an
MTA must attempt to provide in case the configuration file is not parsed and/or accepted in its entirety.
To Next Page
Loading...
