85
If false(2), IPSEC Signaling Security is disabled for both the IPSEC Key Management and IPSEC
protocol (for the specific CMS).
Signaling MIB
This MIB module supplies the basic management object for the PacketCable Signaling protocols. This
version of the MIB includes common signaling and Network Call Signaling (NCS) related signaling objects.
PktcCodecType
Textual Convention defines various types of CODECs that MAY be supported. The list of CODECs
MUST be consistent with the CODEC specification
PKT-SP-CODEC-I05-040113.
PktcRingCadence
Represents a ring cadence in bit string format. The ring cadence representation starts with the first 1
in the pattern (the leading 0s in the MSB are padding and are to be ignored). Each bit represents
100ms of tone; 1 is tone, 0 is no tone.
60 bits are used for cadence representation, the least significant 4 bits represent repeatable
characteristics.
0000 means repeatable, and 1000 means non repeatable.
As an example, the hex representation of a ring cadence of 0.5 seconds on; 4 seconds off; repeatable
would be:
0x1 F0000000000.
PktcSigType
The various types of signaling that may be supported.
ncs —Network Call Signaling; a derivation of MGCP (Media Gateway Control Protocol) version
1.0.
dcs —Distributed Call Signaling; a derivation of SIP (Session Initiation Protocol) RFC 3261.
pktcSigDevCodecTable
This table describes the MTA supported CODEC types.
pktcSigDevCodecIndex
The index value which uniquely identifies an entry in the pktcSigDevCodecTable.
pktcSigDevCodecType
A CODEC type supported by this MTA.
pktcSigDevCodecMax
The maximum number of simultaneous sessions of the specific CODEC that the MTA can support.
pktcSigDefNcsReceiveUdpPort
Contains the MTA User Datagram Protocol (UDP) receive port that is being used for NCS call
signaling. This object should only be changed by the configuration file, default value is
2427.
pktcSigNcsServiceFlowState
Contains a status value of the Call Signaling Service Flow.
not-active indicates that the NCS SF is not being used, and has not tried to be created.
active indicates that the NCS SF is in use.
error indicates that the NCS SF creation resulted in an error and the best effort channel is used for
NCS Signaling
pktcNcsEndPntConfigCallAgentId
Contains a string indicating the call agent name (for example, ca@abc.def.com). The call agent
name after the character
@ MUST be a fully qualified domain name and MUST have a corre-
sponding
pktcMtaDevCmsFqdn entry in the pktcMtaDevCmsTable.
Troubleshooting
To Next Page
Loading...
