- 61 -
C141501700.fm
User's manual
GB
4-Position the robot inside the recharg-
ing station.
5-Carry out battery recharge.
Warning - Caution
Before performing the first recharge,
check that the power supply unit is
suitable for the type of batteries in-
stalled (power supply unit for lead or
lithium batteries) (see "Recharge bat-
teries on first use").
At this point, the robot is ready to use
(see "Use and functioning").
1-Stop the robot in safety condi-
tions (see "Robot safety stop").
2-Turn the robot upside down
and put it down so not to ruin
the covering hood.
3-Remove the screws (B) to re-
move the blade (A).
Important
Use protection gloves to avoid
the risk of cuts on hands.
4-Insert the new blade and fas-
ten screws.
5-Adjust the cutting height (see
"Adjusting the cutting height").
6-Capsize the robot in its functioning
position.
REPLACE THE BLADE
IDM - 41501702900.tif
screws (B)
blade (A)
To Next Page
Loading...
