129
5.6 Log Out
The logged in user can logout by using the button near the top right hand corner of the screen. Once logged
out, the DVR Web Access will return to the login screen, where another user may login. Below is a screenshot of
the login screen:
6. FAQs/Troubleshooting
1. The DVR does not boot up properly.
Below are a few possible reasons why this may be occurring:
• The power input is not correct voltage.
• The power cable connection is not secured correctly.
• The power button is damaged or malfunctioning.
• The firmware was upgraded incorrectly.
• There is an HDD malfunction, or something is wrong with the HDD cable.
• There is damage to the DVR's main motherboard.
2. DVR often automatically shuts down or stops running. Below
are a few possible reasons why this may be occurring:
• The input voltage is too low or is not stable.
• There is an HDD malfunction, or something is wrong with the HDD cable.
• The power button is damaged or malfunctioning.
• Video output signal is not stable.
• The insides of the DVR have accumulated too much dust.
• The temperature is either too hot or too cold.
• The hardware is malfunctioning.
3. The system does not detect a hard drive.
Below are a few possible reasons why this may be occurring:
To Next Page
Loading...
Need help?
General
