24
7. Connect the DVR power cable into the back of the DVR, and then plug in the DVR power adapter into an
electrical socket.
4. Overview of Navigation and Controls
4.1 Startup and Shut down
4.1.1 Startup
Before initial startup, please make sure:
• The rated input voltage matches the output voltage at your location. Please make sure the power wire
connection is secure before pressing the power on-off button.
• Always use a stable current. If necessary, an Uninterruptable Power Supply (UPS) is a good way to ensure
power stability.
Please follow the steps listed below to boot up the device:
• Plug the power adapter into a wall outlet.
• Connect the power cable to the DVR
• Click the power switch on the DVR’s rear panel to supply power to the device.
• Wait a few seconds, and then push the power button on the front of the device to fully power it on.
4.1.2 Shut down
Note:
• When you see the corresponding dialogue box “System is shutting down…” Do not click the power on-off
button directly.
To Next Page
Loading...
Need help?
General
