23
S.M.A.R.T.:
This option allows you to enable the HDD S.M.A.R.T Capability
(Self-Monitoring, Analysis and Reporting Technology). The optional settings are Auto;
Disabled; and ENABLED.
32 Bit Data Transfer:
the optional settings are: Disabled and Enabled.
Floppy A
This item is for specific floppy disk drive settings. Select according to the specification
of the floppy disk you use.
System Memory
This item will show information about the memory modules(s) installed.
3-5 Advanced BIOS Features
CMOS Setup Utility-Copyright(C)1985-2005 American Megatrends. Inc.
Advanced BIOS Features
Advanced Settings
Help Item
¾
Hard Disk Drivers Press Enter
¾
Removable Drives Press Enter
¾
CD/DVD Drives Press Enter
Quick Boot Enabled
1
st
Boot Device CD/DVD:PS-ASUS D
2
nd
Boot Device HDD:PM-WDC WD800
3
rd
Boot Device USB: JetFlash TS2
Boot up Num-Lock On
ACPI APIC Support Enabled
MPS Revision 1.4
Select Power-on state
for Numlock.
↑↓ : Move Enter: Select +/-
: Value F10: Save ESC: Exit F1: General Help
F5: Discard Charges F6: Standard Defaults F7: Optimized Defaults
Hard Disk Drives
Use this item to specifies the boot device priority sequence from available hard drives.
Removable Drives
Specifies the Boot Device Priority sequence from available removable Drives.
CD/DVD Drives
Specifies the boot device priority sequence from available CD/DVD Drives.
Quick Boot
Allows BIOS to skip certain tests while booting. This will decrease the needed to boot
the system.
1
st
/2
nd
/3
rd
Boot Device
Use this item to specifies the boot sequences from available devices. A device
enclosed in parentheses has been disabled in the corresponding type menu.
Boot Up NumLock Status
The default value is On.
On
(default)
Keypad is numeric keys.
Off
Keypad is arrow keys.
ACPI APIC Support
Include ACPI APIC table pointer to RSDT pointer list.
MPS Revision
This option is only valid for multiprocessor motherboards as it specifies the version of
the Multiprocessor Specification (MPS) that the motherboard will use.
To Next Page
Loading...
Need help?
General
