33
Enable/disable the generation of ACPI_PPC, _PSS, and _PCT objects.
ACPI SRAT Table
Enable or Disable the building of ACPI SRAT Table.
3-12-2 Memory Configuration
CMOS Setup Utility-Copyright(C)1985-2005 American Megatrends. Inc.
Memory Configuration
Help Item
DRAM Timing Mode Auto
Memory CLK: 800MHz, N/A
CAS Latency (Tcl): 6CLK N/A
RAS/CAS Delay(Trcd): 6CLK, N/A
Row Precharge Time(Trp): 6 CLK, N/A
Min Active RAS(Trrd): 15CLK, N/A
RAS/RAS Delay(Trrd): 4CLk, N/A
Row Cycle(Trc) 21 CLK, N/A
Write Recover Time(Twr) 6CLK, N/A
Bank Interleaving Auto
Channel Interleaving XOR of Address b
Enabled clock to All DIMMs Disabled
Mem Clk Tristate C3/ATL VID Disabled
Memory Hole Remapping Enabled
DCT Unganged Mode Always
Power Down Enabled Enabled
Options
Auto
DCT0
DCT1
Both
āā : Move Enter: Select +/-
: Value F10: Save ESC: Exit F1: General Help
F5: Discard Charges F6: Standard Defaults F7: Optimized Defaults
Bank Interleaving
Use this item to enable bank memory interleaving. The optional settings are: Disabled;
Auto.
Enable Clock to ALL DIMMs
Enable unused clocks to DIMMS when memory slots are not populated.
Mem CLK Tristate C3 / Alt VID.
Enable and disable Mem CLK Tri-stating during C3 and Alt VID
Memory Hole Remapping
Enable Memory Remapping around Memory Hole.
DCT Unganged Mode
This allows selection of unganged DRAM MODE (64- bit width).
Auto=Ganged Mode; Always= Unganged Mode.
Power Down Enable
Enable or Disable DDR power down mode.