– 20 –
BYPASSING PROTECTION ZONES
Using the 6 Key
This key is used when you want to arm your system with one or more zones
intentionally unprotected. Bypassed zones are unprotected and will not cause an
alarm when violated while your system is armed. All bypasses are removed
when an OFF sequence (security code plus OFF is performed. Bypasses are
also removed if the arming procedure that follows the bypass command is not
successful.
The system will not allow fire zones to be bypassed.
To bypass zones, the system must be disarmed first.
1. + 6 ENTER SECURITY CODE THEN PRESS [6] KEY
(Security Code)
Example: 7 2 9 6 then press the 6 key.
2. ENTER ZONE NUMBERS
(Zone Numbers) Enter the zone number(s) for the zones to be bypassed
(e.g., 01, 02, 03, etc.).
Important! All single digit numbers must be preceded by
a zero (for example, enter 01 for zone 1).
3. B Y P A S S 0 7 F R O N T
U P S T A I R S B E D R O O M
Typical bypass message
WAIT
The keypad will display the word BYPASS along with
each bypassed zone number. Wait for these zones to be
displayed, to be sure that intended zones are bypassed.
4.
* Z O N E B Y P A S S E D *
S Y S T E M R E A D Y
ARM AS USUAL
Arm the system as usual when the keypad displays the
"Ready ” message.
To Next Page
Loading...
