AMERITECH AM100 - To Add a User or Change a Users Code; To Delete a User

– 28 –
SECURITY CODES (cont’d)
To Add a User or
Change a User's
Code
Changing the Master
Code
Follow the proce-
dure for changing a
user's code, but enter
user #02. You will be
prompted to enter
the new code a sec-
ond time to confirm
accuracy.
Important: Temporary users of the system (e.g., babysitter, cleaning staff) should not be
shown how to use any system function they do not need to know, such as bypassing protection
zones for example.
Sequential key depressions for all steps in a procedure must be made within 2 seconds of
one another, or else the entire entry is aborted and must be repeated from its beginning
(e.g., perform steps 1, 2, and 3 below with no delay between steps).
1. + 8 ENTER MASTER CODE THEN PRESS 8 KEY
(Master Code)
Example: 7 2 9 6 then press the 8 key.
2. ENTER USER NUMBER
(User Number) Enter the 2-digit User Number (03-16) for the user
you are adding or changing.
3.
ENTER USER'S CODE
(User's Code) Enter the new 4-digit security code for that user.
To Delete a User
1.
+ 8 ENTER MASTER CODE THEN PRESS 8 KEY
(Master Code)
Example: 7 2 9 6 then press the 8 key.
2. ENTER USER NUMBER
(User Number) Enter the 2-digit User Number (03-16) for the user
whose code you are deleting.
3. -----------
STOP
Wait (about 3 seconds) until the keypad beeps once
before pressing any other key. The code is
automatically deleted.