– 29 –
TESTING THE SYSTEM
(TO BE CONDUCTED WEEKLY)
Using the
5
Key
The 5 key puts your system into a test mode, which allows each protection point to be
checked for proper operation. The keypad sounds a single beep every 40 seconds as a
reminder that the system is in this test mode.
Note: An alarm message will not be sent to your alarm monitoring company during the
following tests.
1.
* * S Y S T E M R E A D Y* *
DISARM THE SYSTEM
Disarm the system and close all protected windows,
doors, etc. The “Ready” message should be displayed and
the green READY indicator (if present on the keypad)
should also be lit .
2. + 5 ENTER THE SECURITY CODE THEN PRESS 5
(Security Code)
Example: 7 2 9 6 then press the 5 key.
3.
LISTEN. The external sounder should sound for 2 seconds
and then turn off.
If the sounder does not sound, CALL FOR SERVICE
IMMEDIATELY.
4. FAULT ZONES. Open each protected door and window in
turn and listen for three beeps from the keypad.
Identification of each faulted protection point should appear
on the display. The display will clear when the door or
window is closed.
(Continued)
To Next Page
Loading...