– 5 –
SYSTEM OVERVIEW (cont’d)
Burglary
Protection
Your system provides three modes of burglary protection: HOME, AWAY, and
INSTANT, and allows you to BYPASS selected zones while leaving the rest of the
system armed. You must turn on or "arm" the burglary protection portion of your
system before it will sense burglary alarms. The system also provides a CHIME
mode, for alerting users to the opening of protected doors and windows while the
system is disarmed. Refer to the other sections of this manual for procedures for
using these features.
The following table lists the four different arming modes and the results of each.
Arming
Features For Each Arming Mode
Mode Exit Delay Entry Delay Perimeter Armed Interior Armed
AWAY Yes Yes Yes Yes
HOME Yes Yes Yes No
INSTANT Yes No Yes No
Security Codes
At the time of installation, you were assigned a personal four digit security code,
known only to you. You must enter the security code when arming and disarming
the system, and when performing other system functions. As an additional safety
feature, other users who do not have a need to know your code can be assigned
different security codes. Refer to the SECURITY CODES section for procedures on
adding security codes to the system.
Fire Protection
The fire protection portion of your security system (if used) is always active and
will sound an alarm if a fire condition is detected. Refer to the FIRE ALARM
SYSTEM section for important information concerning fire protection, smoke
detectors and planning emergency exit routes from the premises.
To Next Page
Loading...
