Version 0A 6
Amplifier Features
This amplifier provides the following standard features:
ɀ 160 through 6-meter operation, full-power on six meters.
ɀ Four conservative linear-service rated 50-volt MOSFET transistors.
ɀ New push-pull stripline PA layout with exceptional VHF performance.
ɀ Energy-efficient solid-state design greatly reduces heat, <100-watts power line
draw on receive.
ɀ Exceptional harmonic suppression.
ɀ Operational in a few seconds, no long filament warm-up time.
ɀ Clean layout with easy-to-service modular construction.
ɀ Quiet variable-speed forced-air cooling system.
ɀ Power module current and voltage meters with LED illumination.
ɀ Accurate PEP Forward and PEP Reflected output power metering.
ɀ Reflected power protection.
ɀ Thermal overload protection.
ɀ Bandswitch error protection.
ɀ Easy to understand front panel LED indicators for rapid fault-error diagnosis.
ɀ Standard negative-going ALC output with front panel adjustment.
ɀ ALC metering and ALC LED indicator.
ɀ Fully-regulated external switch mode power supply, or linear unregulated supply.
ɀ Compact size 14” deep x 7” high x 9.5” wide.
ɀ Weight amplifier section 15 pounds.
To Next Page
Loading...
