Ametek 3050-AM - Software Status and Monitoring

A-4 | 3050-AM Moisture Analyzer
On-Line The PC and analyzer are connected and communicating
properly.
Off-Line The Live Data box is checked on the General tab and the
connection is broken or off-line.
Demo Mode The Live Data box is not checked on the General tab. No
analyzer is connected through the serial port. This allows you
to exercise program options without communication with the
analyzer.
Serial Numbers
The analyzer name and analyzer software version are displayed on the first
line in the upper right-hand corner. The analyzer serial number and sensor
serial number, and the dryer code are also displayed.
In the lower right-hand corner, above the Help button, is the Configurator
software version number.
Saving Your Settings
To save settings on the General tab, click Apply.
To save settings and exit the program, click Apply+Exit.
To abort changes you have made, click Cancel+Exit. This will close the
Configurator software program.
Device Communications Tab
For initial setup of PC communication parameters, use the Setup button
on the General tab.
Con guring Multiple Analyzers
Use the Device Communications tab to set the analyzer’s communication
parameters to agree with the PC settings when controlling analyzers in a
daisy chain.
Changing Communication Parameters
• Change the ANALYZER parameter(s) first.

NOTE