PC Interface | A-5
• Click Apply to confirm the change. This may cause the analyzer to go
off-line.
• Change the PC settings or physical wires/cables.
• Reset the analyzer by recycling power.
Baud Rate
Select the baud rate at which data will be transferred.
RS-485
Identifies the analyzer’s address and the type of serial communication cable
that is being used.
Address Type the network address for the analyzer being con-
nected.
Two-Wire RS-485 Click if you are using a 2-wire cable.
Four-Wire RS-485 Click if you are using a 4-wire cable.
Saving Your Settings
To save settings on the Device Communications tab, click Apply.
To save settings and exit the program, click Apply+Exit.
To abort changes you have made, click Cancel+Exit. This will close the
Configurator software program.
Figure A-3.
Device Communications
setup screen.
To Next Page
Loading...
