Ametek 3050-AM - Software Setup Tab

A-6 | 3050-AM Moisture Analyzer
Setup Tab
Use the Setup tab to define analyzer parameters.
Figure A-4.
Setup tab.
Gas
Select the gas being sampled.
Dewpoint Temp - If you select dewpoint temp, the Process Pressure box
is activated and you must enter a process pressure parameter in kPa.
Units
Select the unit of measurement.
Process Pressure
Enter the process pressure in kPa.
4-20 mA Output
Set up your analog output range.
20 mA Enter your high analog output limit.
4 mA Enter your low analog output limit.
Hold during Zero Check this box to hold analyzer output during verification
and zero.
Alarm Output
Set up the limits for the concentration alarm.
Enable Check this box to enable the concentration alarm.
High Limit Enter the high limit for the concentration alarm.
Low Limit Enter the low limit for the concentration alarm.

NOTE