PC Interface | A-7
Schedule Tab
Use the Schedule tab to schedule routine Zero.
NOTE
Figure A-5.
Schedule tab.
Abort Button
Click to terminate verification or zero.
Zero Now Button
Click to begin zero cycle now.
Adjust O set check box
Checked The analyzer performs an offset adjustment at the end
of the zero cycle.
Not checked The analyzer verifies only.
Set Clock
(Time Synchronization) Click Set Clock to synchronize the clock within the
analyzer with the PC. The Time Synchronization box opens with the PC
time and date and the analyzer time and date. Click Synchronize to set the
time, or click Cancel to close the box.
Set Dryer Production Code
Click to enter the Dryer Production Code for the dryer that is installed in
the analyzer. Click OK to accept.
You must enter a new dryer code each time you replace the dryer.
To Next Page
Loading...
