Ametek Drexelbrook Universal IV User Manual

Quick Start Guide
19
3.1.5 Commissioning
Start-up checklist
Do not connect power until you have gone through the checklist
below
1.Arethewettedcomponents(gasket,flangeandsensing
element)resistanttothecorrosivepropertiesofthetank
product?
2. Does the information given on the nameplate correspond with
the application?
3.Exdapplications:Haveyouconnectedtheequipotential
bonding system correctly?
4.Exiapplications:Areyouusinganintrinsicbarrierwithin
the correct parameters?
5. Did you install cable entries of the correct internal diameter
so that there is a good seal around the cable? Are the
cable glands suitably certified per the application and the
hazardous area parameters?
6.Donotusetheearthterminalinthewiringcompartment:use
the equipotential bonding system.
3.2 The Compartment Cover
ViewportCleaning:TheviewportismadeofBorosilicateglass
and can be cleaned with any common glass cleaning product
(e.g.:Windex™,Isopropylalcohol,etc.)thatissuitableforthe
Class and Division rating of the specific system installation.
3.2.1 Opening the cover
Procedure
1. Unscrew cover stop, if applicable
2. Unscrew terminal compartment cover
3.2.2 Closing the cover
Warning: Ex d [ia] applications
Check that the terminal compartment cover is screwed tight and
thecoverstop(ifapplicable)isfastenedtightlytothecover.

Ametek Drexelbrook Universal IV Specifications

General

Brand	Ametek
Model	Drexelbrook Universal IV
Category	Measuring Instruments
Language	English