9. Maintenance
9.1 Replacing Batteries
Replace batteries as soon as the battery indicator turns on to avoid false
measurements. If the batteries discharge too deeply the ASC 300 will
automatically shut down to avoid battery leakage.
Note: Use only AA size alkaline batteries or optional rechargeable battery
pack.
9.2 Cleaning the Unit
Warning
To avoid personal injury or damage to the calibrator, use only the specified
replacement parts and do not allow water into the case.
Caution
To avoid damaging the plastic lens and case, do not use solvents or
abrasive cleansers.
Clean the calibrator with a soft cloth dampened with water or water and mild
soap.
9.3 Service Center Calibration or Repair
Only qualified service personnel should perform calibration, repairs, or
servicing not covered in this manual. If the calibrator fails, check the
batteries first, and replace them if needed.
Verify that the calibrator is being operated as explained in this manual. If the
calibrator is faulty, send a description of the failure with the calibrator. Be
sure to pack the calibrator securely, using the original shipping container if it
is available.
52
!
!
To Next Page
Loading...
