To Next Page

To Previous Page

12 23-03-2009 105446 06

 The tip of the sensor should rest at the bottom of the

sensor basket for optimum results (liquid baths only).

 Be careful not to submerge the handle or wire inlet of

the sensor-under-test in the fluid, as this might damage

the sensor (liquid baths only).

Note…

The product liability only applies if the instrument is

subject to a manufacturing defect. This liability becomes

void if the user fails to follow the instructions set out in this

manual or uses unauthorised spare parts.

Ametek JOFRA ATC-125 User Manual

Other manuals for Ametek JOFRA ATC-125