22 23-03-2009 105446 06
3.3 Preparing the liquid bath calibrator
Warning
The calibrator must not be used for any purposes other
than those described in this manual.
The calibrator has been designed for interior use only
and should not be used in hazardous areas, where
vapour or gas leaks, etc. may constitute a danger of
explosion.
Liquid baths should only be operated by trained
personal.
AMETEK Denmark A/S does not take any
responsibility, if the well is filled with other fluids than
those recommended.
Heat transfer fluids must only be used in calibrators
with an liquid bath. If these fluids are overheated they
will create noxious or toxic fumes. Proper ventilation
must be used.
Product information on the fluid must be carefully
investigated before use.
The calibrator must be kept free within an area of 20
cm on all sides and 1 metre above the calibrator.
Note…
The instrument must not be exposed to draughts.
To Next Page
Loading...
Need help?
General
