105446 06 23-03-2009 7
2.0 Safety instructions
Read this manual carefully before using the
instrument!
In order to avoid any personal injuries and/or damage to
the instrument all safety instructions and warnings must be
observed.
Disposal – WEEE Directive
These calibrators contain Electrical and Electronic circuits
and must be recycled or disposed of properly (in
accordance with the WEEE Directive 2002/96/EC).
Warning……
About the use:
The calibrator must not be used for any purposes other
than those described in this manual.
The calibrator has been designed for interior use only
and should not be used in hazardous areas, where
vapour or gas leaks, etc. may constitute a danger of
explosion.
The calibrator must be kept free within an area of 20
cm on all sides and 1 metre above the calibrator.
Never use heat transfer fluids such as silicone, oil,
paste, etc. in the dry-block calibrators. These fluids may
penetrate the calibrator and cause damage or create
poisonous fumes.
The calibrator must be switched off before any
attempt to service the instrument is made.
When cleaning the well, REMEMBER to wear goggles
when using compressed air in the dry-block calibrator
and cleaning oil in the liquid bath calibrator.
To Next Page
Loading...
Need help?
General
