Ametek NetWave 3.1 - Page 41

AMETEK CTs NetWave
1 Signal out (control)
2 Source in (control)
3 Trigger IN1/2
4 Trigger OUT 1/2
5 GPIB / IEEE 488 port
6 USB for data storage
7 Ethernet port
8 Serial from DPA 503
9 Framebus OUT
10 DUT monitor
11 USB 2 option measuring board
11 USB Interface for Measure & Analyze option
USB interface to operating PC, for the Measure &
Analyze Option
Only required if NWBoard 3Phase Option is
available