on
28 SPECTROLAB —
6.4 Measuring procedure
Warning of hand injury!
Springs are used to keep the sample clamp in position. However, the clamp may
fold down unexpectedly. If your hand is caught underneath the clamp, this may
cause injuries.
Never place your hand under the sample clamp.
Warning of hazardous voltage!
The sample clamp provides the contact between the sample and the spark stand.
There is a risk of electric shock when handling the sample clamp.
Never tamper with the sample clamp.
Warning! Hot surface!
A samp
le can get hot if it is measured several times.
Touch the sample only after it has sufficiently cooled.
Warning! Optical radiation!
The plasma in the spark stand generates UV radiation. UV radiation may cause
damage to the eyes or skin.
For samples that do not completely cover the spark stand opening, use the
respective sample adapters in such a way that the opening is completely
closed.
Take appropriate protective measures (e.g. wear safety goggles) when the
spark stand opening is not fully covered.
Information
A flawed initial start
-up, operation or sample preparation can lead to measurement
Therefore, ensure all necessary requirements for a correct measurement are
met.
To Next Page
Loading...
Need help?
General
