45
A.1.2 Transfer of a bulk of programs
To transfer a bulk of programs from the Master machine to the Slave machine, proceed as follows on the
MASTER machine:
- Press F4
- Use the yellow arrow keys to position the cursor on the 1st program to be transfered.
- Press F2
- Type in the last code number of the programs to be transfered, then press enter
- Type in the 1st code/line number on the Slave machine where you want to place the selected programs
- Press Enter to confirm the transmission
A.1.3 Transfering all the programs stored in the Master machine
To transfer all of the programs from the Master machine to the Slave machine, proceed as follows:
- Press the F4 key
- Press the F3 key
The programs will be input into the Slave machine in the same position they had in the master machine. They
will replace any programs present in the Slave machine before the transfer.
To Previous Page
Loading...