SM-4 Series Stereo Microscope
AmScope Proprietary Page 18 of 37
1. Place the camera directly into the trinocular
port.
2. Plug one end of the cord into the camera
and the USB end into your computer.
3. To focus through the trinocular port, turn
middle portion of the tube.
4. Open up your AmScope Digital Camera
Solution software on your computer and let
it connect to your microscope.
To focus through the trinocular port (simul-focal models only), simply turn
middle portion of the tube, after focusing the eyepieces. If you have
difficultly focusing them at the same time, adjust the diopter as described
in section 2.4.4.
2.6 Adjusting Focus Tension
To adjust the tension of the
focusing knobs, look for the
focusing knob marked “Tension”.
Find the matching focusing knob
on the other side of the focusing
rack. Always turn the focusing
knobs in opposite directions. If you
are turning one clockwise, turn the
other one counterclockwise.
To tighten tension, turn the focusing knob
marked tension clockwise and the other
focusing knob counterclockwise.
To loosen tension, turn the focusing knob
marked tension counterclockwise and the
other focusing knob clockwise.
Be careful not to loosen the tension too much
or the focusing rack will not stay in place.
Make sure the tension is tight enough to
support the head and any accessories you
may add.
To Next Page
Loading...
