User Manual - CTC-1402
13
Receiver Front Panel Description
No. Name Description
1 POWER LED
(Green)
On: The CTC-1402 RX is powered on.
O: The CTC-1402 RX is powered o.
2 Auto Auto Switch Button: Press to Enable/Disable auto switching function.
LED: LED is located on the top of the button.
• ON: Input auto switching function is enabled (default).
• O: Input auto switching function is disabled.
3 HDBT HDBT IN button: Press to select HDBT input.
LED: LED is located on the top of the button.
• Green: the input has signal and is selected.
• Yellow: the input has signal but is not selected.
• Red: the input has no signal but is selected.
• O: the input has no signal and is not selected.
4 HDMI 1 HDMI 1 (RX) Button: Press to select RX HDMI IN 1 as input.
LED: LED is located on the top of the button.
• Green: the input has signal and is selected.
• Yellow: the input has signal but is not selected.
• Red: the input has no signal but is selected.
• O: the input has no signal and is not selected.
5 HDMI 2 HDMI 2 Button: Press to select RX HDMI IN 2 source as input.
LED: LED is located on the top of the button.
• Green: the input has signal and is selected.
• Yellow: the input has signal but is not selected.
• Red: the input has no signal but is selected.
• O: the input has no signal and is not selected.
6 Display Display control Button:
Short press - Set all the displays on.
Hold press for 3s - Set all the displays o.
LED (Blue): LED is located on the top of the button.
• Blinking 1 time: Short Press the button, then LED extinguishes after nishing operation.
• Blinking 3 times: Hold press the button for 3 seconds, LED extinguishes after nishing operation.
7 Relay 1 Relay 1 Button: Press to set the screen closed.
LED (Green): LED is located on the top of the button.
Short press the button, LED blinks 1 time then extinguishes after nishing the operation.
8 Relay 2 Relay 2 Button: Press to set the screen open. LED (Green): LED is located on the top of the button.
Short press the button, LED blinks 1 time and extinguishes after nishing the operation.
To Next Page
Loading...
Need help?
General