To Next Page

To Previous Page

User Manual - CTC-1402

Send Commands to Control a Device

Click “Diagnostics” on the menu bar, choose “Control a Device”.

A window will display as follows, enter a command in the textbox, and click “Send To Device”. (For API commands, see the Section API

Command Set.)

Telnet Control via NetLinx Studio

1. Choose the device you want to control, right click, then choose TELNET Window->Launch TELNET window via NetLinx Studio,

enter the Telnet window, input the Telnet API in this window to control the device.

Note: For API Commands, see the section API Command Set

Questions and Answers:

Need help?

Do you have a question about the AMX CTC-1402 and is the answer not in the manual?

AMX CTC-1402 Specifications

General