User Manual - CTC-1402
14
Receiver Rear Panel Description
No. Name Description
1 HDBT IN Connect to the CTC-1402 transmitter via a shielded Cat 6A/7 cable.
2 HDMI IN 1-2 Connect to an HDMI sources.
3 HDMI OUT Connect to an HDMI display.
4 AUDIO OUT Connect to the audio system with the Phoenix Connector.
5 IR TX Connect to an IR emitter cable for emitting remote signal from TX.
6 RESET When CTC-1402 RX is powered on, use a pointed stylus to hold down the RESET button for 3 seconds
or more, then release, the unit will reboot and restore to its factory defaults.
7 12V Connect to the provided DC 12V power adapter .
8 DEVICE Connect to USB devices.
9 Host 1 Connect to a PC which is followed with HDMI IN1, when the source is selected. The USB devices (on TX
and RX) can be connected to a host PC.
10 Host 2 Connect to a PC which is followed with HDMI IN2, when the source is selected. The USB devices (on TX
and RX) can be connected to host a PC.
11 RS232-P Connect an RS232 device to RS232-P of TX, and a device to RS232-P of RX for RS232 pass-through.
RS232-C Connect to an RS232 slave device (such as a projector). Send commands via NetLinx Studio.
13 Relay 1 Connect to a screen with Phoenix Connector for closing the screen.
14 Relay 2 Connect to a screen with Phoenix Connector for opening the screen.
15 LAN 10/100
1-2
Connect to Ethernet devices.
To Next Page
Loading...