User Manual - CTC-1402
20
Input Source Switching
The CTP-1402 Kit supports Auto and Manual button switching between the HDBT (HDMI, VGA) and HDMI inputs.
Auto Switching
Press AUTO button. The Auto Switching function will be enabled immediately.
1. If more than one input ports have active signal, the priority order is VGA 1 > DP IN 2 > HDMI IN 3 > USB-C > RX HDMI IN 1 >
RX HDMI IN 2;
2. New insert: LIFO (Last In-First Out);
3. New pull out: When the selected source is pulled out, the unit switches to the last selected port. If there is no active signal,
the unit switches to the port with the highest priority;
4. If all input ports have no active signal, the RX HDMI IN 1 is set to active.
Note:
• The Auto Switching function is enabled by default once all devices are powered on.
• Auto Switching can be set to Enabled or Disabled through NetLinx Studio and the front panel button.
• Power-o protection: When Auto Switching or Manual Switching are selected before powering o, the device will remain in
the same mode after powering back on. When Auto Switching is selected before powering o, and the previously selected
port has active signal after powering the device back on, the port will remain selected. If the port is not active, and more than
one input ports have active signal, Auto Switching will follow priority order.
Manual Switching
Press the AUTO Button (ensure AUTO LED is o) or the specic input button (in red frames above) to enable Manual Switching. In
Manual Switching mode:
1. When the input port with no source is selected, CTC-1402 will output no signal;
2. If the Power is cycled, on the CTC-1402, the Manual Switching function will remain enabled.
Note:
• Manual Switching is also available when Auto Switching is on, but will only apply to active input sources.
• Manual Switching will remain available when Auto Switching is o, and can switch among inactive input ports.
To Next Page
Loading...
Need help?
General