AMX CTC-1402 - Page 44

User Manual - CTC-1402
44
No. Function Description Syntax Example
10 ?CEC_DISP_AUTO
To verify the display
control Status
Command:
SEND_COMMAND <DEV>, “’?CEC_DISP_
AUTO’”
Return:
CEC_DISP_AUTO-<ON|OFF>
Command:
SEND_COMMAND SWITCHER,”’?CEC_DISP_
AUTO’”
Return:
CEC_DISP_AUTO-ON
Description:
Get the display control Status. The display
control status is on.
11 CEC_SLEEP_TIMEOUT
To dene a Delay Time
to control the display o
when on active signal
Command:
SEND_COMMAND <DEV>,”’CEC_SLEEP_
TIMEOUT-<time>’”
Return:
CEC_SLEEP_TIMEOUT-<time>
Description:
time: {1 ~ 30}
Command:
SEND_COMMAND <DEV>,”’CEC_SLEEP_
TIMEOUT-5’”
Return:
CEC_SLEEP_TIMEOUT-5
Description:
Set Delay Time is 5 Minutes
12 ?CEC_SLEEP_TIMEOUT
To verify Delay Time to
control the display o
when on active signal
Command:
SEND_COMMAND <DEV>, “’?CEC_SLEEP_
TIMEOUT’”
Return:
CEC_SLEEP_TIMEOUT-<time>
Description:
time: {1 ~ 30}
Command:
SEND_COMMAND SWITCHER,”’?CEC_SLEEP_
TIMEOUT’”
Return:
CEC_SLEEP_TIMEOUT-5
Description:
Get Delay Time to control the display o when
on active signal. The Delay Time is 5 Minutes.
13 VIDIN_PREF_EDID
To Set input EDID
Command
SEND_COMMAND <DEV>,”’VIDIN_PREF_
EDID-<resolution>’”
Return:
VIDIN_PREF_EDID-<resolution>
Description:
Input port:
//{
VGA_IN;
DP_IN;
TX_HDMI_IN;
USB-C_IN;
RX_HDMI_IN1;
RX_HDMI_IN2;
}
<resolution>
{
For VGA Input
1920x1200,60
1920x1080,60
1680x1050,60
1600x900,60
1440x900,60
1360x768,60
1280x768,60
1024x768,60
For HDMI Input
3840x2160,60
3840x2160,30
1920x1080,60
1280x720,60
1920x1200,60
1680x1050,60
1600x1200,60
1600x900,60
1440x900,60
1400x1050,60
1366x768,60
1280x1024,60
1280x960,60
1024x768,60
COPY
}
Command:
SEND_COMMAND VIDEO_INPUT_2,”’VIDIN_
PREF_EDID-1920x1200,60’”
Return:
VIDIN_PREF_EDID-1920x1200,60
Description:
Set x EDID(1920x1200@60Hz 2CH)
NetLinx Commands (cont.)