39
4. The hoop does not
turn.
The hoop speed control is at 0.
Move the control forward between
2 and 10.
The drive wheel slides on the hoop.
Ti
hten the wheel sprin
.
Check tire air pressure and ad
ust
if necessary.
Chan
e the tire if it is worn out.
The drive wheel does not turn.
Check oil level. Check for leaks.
Chec
the condition of the wheel
motor and change it if necessary.
The actuator lever does not move
the pointer.
See section 8-ad
ustment
procedures.
5. The hoop and the
pusher lose speed.
Lack of hydraulic oil or oil pressure.
Check oil level. Check for lea
s.
Adjust as needed.
6. The pusher moves
forward at normal
speed but the hoop
turns slowly.
The wrappin
speed control is at too
low a setting
Increase wrappin
speed.
The actuator lever does not move
the pointer.
See section 8-ad
ustment
procedures p.27
7. The speed control
lever is blocked.
Water infiltration may have caused
the interior to rust.
Take apart the speed control and
lubricate it.
8. The plastic film
breaks at normal
temperatures.
The film is not tight enough.
Check that the plastic film roll is
installed as indicated in the
diagram.
Check that stretcher and sprin
parts are in good condition.
Debris have become wrapped
around the rolls or in the stretchers.
Remove the debris and check the
general condition of the stretchers.
The aluminum rollers are dirty.
Clean them with penetratin
oil.
The rubber roller is dama
ed.
Replace the rubber roller.
The spikes have become rou
h.
Gently sand the spikes.
9. The plastic film
often breaks in hot
weather.
The stretcher sprin
s are puttin
pressure on the hoop.
Unhook the stretcher sprin
s.
10. The remote starter
does not work or has
stopped working.
The engine key is in OFF position.
Turn the key to ON position.
The remote control battery has lost
its charge or has a bad contact.
Check the contact or chan
e the
battery. Reprogram the remote
starter (see instructions).
The Honda en
ine fuse has burned
out.
Chan
e the fuse.
To Next Page
Loading...
Need help?
General
